BMW X2 2021 Owner's Manual page 195

Adjusting
Turn the wheel to set the desired
temperature.
The selected temperature is shown on the dis‐
play of the automatic climate control.
Do not rapidly switch between different tempera‐
ture settings. Otherwise, the automatic climate
control will not have sufficient time to adjust the
set temperature.
Air conditioning
Concept
The air in the car's interior will be cooled and de‐
humidified and, depending on the temperature
setting, warmed again.
The car's interior can only be cooled with the en‐
gine running.
Switching on/off
Press the button.
The LED is illuminated with air condi‐
tioning switched on.
Depending on the weather, the windshield and
side windows may fog up briefly when the en‐
gine is started.
Air conditioning is switched on automatically with
the AUTO program.
When using the cooling mode, condensation that
will exit below the vehicle.
Maximum cooling
Concept
The system is set to the lowest temperature, op‐
timum air flow and air recirculation mode.
Online Edition for Part no. 01405A2CF16 - II/21
Climate control
Functional requirement
The function is available above an outside tem‐
perature of approx. 32 ℉/0 ℃ And with the en‐
gine running.
Switching on/off
Press the button.
The LED is illuminated with the system
switched on.
Air flows out of the vents to the upper body re‐
gion. The vents need to be open for this.
The air flow can be adjusted with the program
active.
AUTO program
Concept
The AUTO program cools, ventilates or heats
the car's interior automatically.
The air distribution and temperature are control‐
led automatically depending on the temperature
in the car's interior and the desired temperature
setting including the selected intensity of the air
flow.
Switching on/off
Press the button.
The LED is illuminated with the AUTO
program switched on.
Depending on the selected settings and outside
influences, the air is directed to the windshield,
side windows, upper body, and into the floor
area.
Air conditioning, refer to page 195, is switched
on automatically with the AUTO program.
Point the side vents toward the side windows.
At the same time, a condensation sensor con‐
trols the program so as to prevent window con‐
densation as much as possible.
CONTROLS
195