Table of Contents
Advertisement
Default Setpoints and Configurations
Section 1: Summary of Default Settings
Setup information consists of the process setpoints and the film Processor configurations. All setup
information that was preset at the factory is listed in the tables below.
Setup information is stored in battery backed-up RAM (Random Access Memory). Therefore, you do
not need to program new values every time that you turn on the Processor. Even if power to the
Processor is interrupted or the Processor is turned off, you do not need to program the Processor.
If you wish, you may change the setup information by using the Soft Keys on the Display Panel. See
the following pages for instructions on how to set up the Processor.
Table 1 Default Processor Configurations for All Cycles
Access Code
Processing Cycle
Dryer Temperature
Time and Date
Pump Calibration
Alarm Volume
Replenishment Mode
Temperature Lockout Mode
Display Units
Receptacle Mode
Standby Mode
Display Language
Access to Processor Setup
Sleep Mode Options
Roller Jog
Cool Down
Automatic On and Off Timers
*Operator Must Ensure That Setting is Correct for the Application.
5B6328 – 30SEP98
4-2-1-3
*Standard
*43°C (110°F)
Operator Must Enter
Operator Must Complete
Mid Range (7)
Automatic
Disabled
°F, in./min
Safelight Mode
Interval
English
Allowed
Off
Off
Off
Summary of Default Settings
19
Advertisement
Table of Contents
