Fittings And Tubing - EK-Quantum Vector2 Strix/TUF RTX 4090 D-RGB ABP Set User Manual
Gpu water block
Hide thumbs
Also See for Vector2 Strix/TUF RTX 4090 D-RGB ABP Set:
- User manual (23 pages) ,
- Manual (21 pages) ,
- Quick start manual (16 pages)
Table of Contents
Advertisement
M4 x 20 DIN7984
SCREW
TERMINAL BADGE
FITTINGS AND TUBING
EK- PLUG
G1/4
TUBING
M3 x 10 AX1 SCREW
STEP 3
EK-FITTING
STEP 1
STEP 3
Place five (5) M3 x 10 AX1 screws into the water block standoffs
and tighten them using a Philips head screwdriver (as shown in the
image). After attaching the AX1 Screws, three (3) terminal screws
M4 x 20 DIN7984 need to be attached using Allen Key 2.5 mm. The
terminal badge can be reused, after securing the terminal screws.
For this step, you will need:
Phillips Head Screwdriver
STEP 1
Screw in two (2) G1/4 threaded male fittings. Attach the liquid
cooling tubes and connect the water block to the cooling loop.
Do not forget to plug the remaining two openings with the
enclosed EK-Plug G1/4 or its equivalent.
EK recommends using EK fittings with all EK water blocks.
CAUTION: When using connectors other than EK fittings,
pay special attention to the length of the fittings' male G1/4"
thread – 5 mm is the maximum G1/4" thread length allowed!
- 18 -
Allen Key 2.5mm
Advertisement
Table of Contents
Need help?
Do you have a question about the Vector2 Strix/TUF RTX 4090 D-RGB ABP Set and is the answer not in the manual?