Fittings And Tubing; Connecting The D-Rgb Led Strip - EK-Quantum Vector2 Strix/TUF RTX 4080 D-RGB User Manual

FITTINGS AND TUBING

TUBING

CONNECTING THE D-RGB LED STRIP

EK- PLUG G1/4
EK-FITTING
D-RGB HEADER
RGB HEADER
STEP 1
Screw in two (2) G1/4 threaded male fittings. Attach the liquid
cooling tubes and connect the water block to the cooling loop.
Do not forget to plug the remaining two openings using
the enclosed EK-Plug G1/4 or its equivalent.
EK recommends using EK fittings with all EK water blocks.
CAUTION: When using connectors other than EK fittings,
pay special attention to the length of the fittings' male G1/4"
thread – 5mm is the maximum G1/4" thread length allowed!
For this step, you will need:
EK-Loop Multi Allen Key
STEP 1
Plug the 3-pin connector of the distribution plate D-RGB LED
light to the D-RGB HEADER on the motherboard. The LED will
work if the pin layout on the header is as follows: +5V, Digital,
Empty, Ground.
Incorrect installation or installation to a wrong header can
damage the LED strip or the header itself!
- 18 -