Advertisement
01
OFF
5.17 - Locking and unlocking the memory
This procedure allows you to lock or unlock the memory to prevent accidental memorisation of other transmitters not included in the system.
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. Keep the s and t keys pressed simultaneously and wait for the motor to perform 2 movements. Upon completion, release the keys.
05. • To unlock the memory: Keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
• To unlock the memory: Keep the t key pressed and wait for the motor to perform 5 movements. Upon completion, release the key.
01
5
sec.
04
5
sec.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
6
OPTIONAL ACCESSORIES
6.1 - Control pushbutton strip (wall-mounted)
6.1.1 - Installation of the pushbutton strip
this accessory can be used as an alternative to the radio transmitter to send, by wire,
the controls to the motor when using the automation.
Installation warnings:
• it is recommended to use an unstable pushbutton strip with interlocked pushbut-
tons.
• The mechanical operation of the push buttons must be exclusively of the "with
operator present" type: in other words, and they are released, they must return to
their initial position. Note – When the limit switches are already adjusted, all you
need to do is simply press the pushbutton with one pulse to activate the move-
ment of the awning which will terminate automatically when it reaches the limits
which you have adjusted.
• You can choose models with one or two pushbuttons according to your needs:
The model with two push buttons activates the Raise and Lower input; the model
with one pushbutton can activate the TTBus / Open / Step-to-step (the type of
02
white
white-black
02
2
2
03
04
ON
3
5
sec.
05
5
sec.
05
5
sec.
input is selected with the procedure 6.A).
• The pushbutton strip must be positioned as follows:
– in a place that is not accessible to outsiders/strangers;
– where you can see the awning from but far from its moving parts;
– on the side of the awning where there is the electrical cord from the motor and
the power cord from the electrical mains (fig. 4-h);
– at a height no less than 1.5 m from the floor/ground.
6.1.2 - Connecting the pushbutton strip
CAUTION! – The maximum length of the cables used to connect a wall-
mounted panel or a relay, is 100 m.
A - Pushbutton strip with 2 push buttons (wires to use: White + White-Or-
ange + White-black): to connect this accessory, see fig. 3.
B - Pushbutton strip with 1 push buttons (wires to use: White + White-
black): to connect this accessory, see fig. 3.
01
02
03
04
Paragraph 5.16.1
03
3
5
sec.
3
5
05
English – 12
Advertisement
