Page 1
Waterford Stanley Ltd. Bilberry, Waterford Ireland. Tel: (051) 302300 Fax: (051) 302375 FT20 G FAN FLUE FOR BRANDON GAS COOKERS FITTED WITH PREMIX BURNERS INSTALLATION & COMMISSIONING INSTRUCTIONS...
POSITION OF FT 20 G POWER FLUE FOR GAS FIRED COOKERS Car port (open sides) GAS FIRED COOKERS - MINIMUM DISTANCES TO TERMINALS ARE AS FOLLOWS: Directly below an opening, air brick, window etc. Below a gutter, eaves or balcony with protection. Below a gutter or a balcony without protection.
FT 20 G POWER FLUE KIT ASSEMBLY SEE EXPLODED VIEW (FIG 8) WHEN ITEM NUMBERS ARE REFERRED TO: INSTALLATION Fig.4 Fig.5 STEP 1. (a) Remove the air inlet plate on the bottom right hand corner on the front of the cooker. (b) Remove the blanking plate on the bottom left hand corner on the rear of the cooker.
STEP 4. Note: Seal around the joints where NOTE: It is essential that the Connect the speed controller to the the fan interfaces with the horizon- draught be correctly set as it can cooker loom by first removing the tal flue section. effect the input rate of the appli- blanking 6-way connector and then ance.