Band Width; Reverse; Busy Lock; Tx Prohibit - Alinco DJ-MD 5E GPS Operation Manual

TONE: You can hear the call when the channel receives a matched signaling.
C&T: You can hear the call when the channel receives a matched CTCSS/ DCS and
matched tone signaling.
C|T: You can hear the call when the channel receives a matched CTCSS/ DCS or
matched signaling

10.Band Width

Choose wide band or narrow band for the analog channel.

11.Reverse

When this function is enabled, the RX frequency, TX frequency and CTCSS/DCS
encode/decode will be reversed.

16.Busy Lock

Always: Always allows transmissions
Repeater: Will not allow transmit when receiving matched carrier but unmatched
CTCSS/DCS.
Busy: Will not allow transmit when receiving matched carrier.

17. TX Prohibit

Off: Allow transmit in current channel.
On: Prohibit transmit in current channel.
18. OWN ID
When the analog channel set up with optional signal, you can check the radio ID
number in this menu. The ID number should be set up in PC software  Analog 
Analog Address Book.
19. DTMF Enc
Set a DTMF ID as the default call ID for the current channel.
Press the PTT key to transmit the selected DTMF ID.
Edit the DTMF ID in Menu or with the PC programing software.
20. 2Tone Enc
Set 2Tone is an optional sigal for the current channel by using PC software. Set "call"
is a function of a programmed key.
27