Receiving And Responding To A Radio Call - Alinco DJ-MD 5E GPS Operation Manual

Operation 1: Turn the channel knob to select a channel.
Operation 2: Input the channel numbers by the keyboard. For example, if you want
switch to channel 99, input 0 0 9 9 a total of 4 digits, and it will switch to channel 99.

5.9 Receiving and Responding to a Radio Call

When the radio is in the digital mode, it can receive and respond to a call with the
same frequency/color code/ slot.
1. If radio is programed with callers DMR ID number in digital contact list, when
receiving a call, depend of the setting radio will ring.
2. LED lights green up (Analog channel mode), or LED lights cyan up (Digital
channel mode).
3. Left top corner of LCD shows RSSI icon, radio also displays DMRID/ name/ city/
state/ country /call type and incoming icon base on setting.
4. When a call ends, radio displays "Call end" message.
Making a Call
There are 3 ways to select a target radio when making a call.
Operation 1: from the Channel knob.
Turn the channel knob to choose your desired channel then press PTT to make a call.
Operation 2: from contact list.
Press (EXIT) to enter the contact list then press
press PTT to make a call.
Operation 3: from the keypad.
( MENU) key to enter the menu setting, select "Contacts" then select
Press
"Manual Dial ". Input the ID number by keypad, press
Private DMR ID then press PTT to make a cal
Hold the radio vertical 2.5-5cm from your mouth is recomended, press the [PTT] key
to start the call, the red LED lights up, the receiver ID/name/city/state/country/ call
type and call out icon will be display on the LCD.
Release [PTT] key to receive the reply.
/ key a stored contact then
key to switch group ID or
10