Talk Around; Name; Tx Allow; Tx Prohibit - Alinco DJ-MD 5E GPS Operation Manual

8. Talk Around

As normal a radio communicates to a target radio through a repeater (TX and RX
frequency are set as different values). This option allows 2 radios communicate to
each others but you don't want to change frequency settings when repeater is out of
range or when the repeater is down. It works in both digital and analog channel. When
talk around set the transmitting radio`s TX and RX frequency are interchanged. Turn
off Talk Around when you want to communicate through repeater as normal.
Note: In analog channel the RX CTCSS/DCS decode is TX CTCSS/DCS encode and
vice versa.

9. Name

Allow edit the channel name via input character by keypad. This function is only valid
in memory channel mode.

10. TX Allow

Always: Always allow to transmit.
Channel Free: Allow to transmit when the channel is free.
Different CC: Allow to transmit when radio receives a matching carrier signal but
different color code.
Same CC: Allow to transmit when radio receives a matching carrier signal and it has
same color code.

11. TX Prohibit

TX ON: Will allow to transmit on the current channel.
TX OFF: Will not allow to transmit on the current channel.

12. Radio ID

In Digital channel: it will show the DMR ID which must be programmed in the PC
software Digital  Radio ID list  Radio ID.
It allows to edit and select an ID for the channel, each channel is allowed to select one
ID.

13. Color Code

The digital channel should have the same color code for communication as defined by
the repeater to be used. which can be programmed in the PC software or defined in the
Menu setting.
If 2 radios are using the same frequency but different color code it could not
communicate to each others.
24