Ana Sq Level; Power Save; Tbst Sel (Tone Burst); Vox - Alinco DJ-MD 5E GPS Operation Manual

19. Ana SQ Level

Selectable 5 squelch levels to receive signal with different signal strength. This
function is only valid for analog channel.

20. Power Save

Turn on to active the power save function, to prolong the battery life.
Save 1:1, work 30ms, dormant 30ms.
Save 2:1, work 60ms, dormant 30ms
When turn on the power save, it may not receive the message in time.

21. TBST Sel (Tone Burst)

Tone burst frequency is used to activate some dormant repeaters, 1000Hz, 1450Hz,
1750Hz, 2100Hz a total of 4 options are offered. Press PTT and PF1 key together to
transmit the tone burst.

22. VOX

Enable the VOX, you can speak into the microphone to start transmitting instead of
pressing the [PTT] key. A total of 3 levels of sensitive VOX are provided.

23. VOX Delay

When the VOX is enabled, set up the VOX delay to delay a period of time to avoid
unwanted transmission so early. Selectable time period 0.5s-3s, a total of 26 levels are
offered.

24. Scan Mod

This function is only valid for a VFO scan.
SCM TO: When an incoming signal is catched, radio stops scan and stays at the
channel 5s before resuming the scan.
SCM CO: When an incoming signal is catched, radio stops scan and stays at the
channel until the signal disappears, and resumes scan approx 2s later.
SCM SE: When an incoming signal is catched, radio terminates the scan.

25. Mic Level

There are 5 levels to selectable the Microphone gain, level 1 is the lowest, level and 5
is highest gain.
20