Table of Contents
Advertisement
on the current channel, if you turn to other channel you may need to turn on CH measure
with corresponding channel.
20.DMR Mode
Select Simplex or Repeater or Double Slot:
21.Slot Suit
Select On or Off.
Turn on Slot suit, the radio will receive the call from both time slots, after the call
press PTT the radio will call back by received call time slot. One you selected slot
suit is On, before receiving a call you can go to slot time to select slot , which you
want to use, if the user does not set the time slot , press PTT to transmit radio will
work on the default time slot 1.
※Chan Set (Analog Channel)
When the channel type is analog, it will auto hide the digital menus, instead, the
channel set will show the analog menus.
The below listed menus are for analog channel only, other not listed menus are same
as the digital channel.
4.TCDT
Set up the CTCSS/DCS code for the TX.
5.RCDT
Set up the CTCSS/DCS code for the RX.
6.RTCDT
Set up the CTCSS/DCS code for both TX and RX CTCSS code: 62.5Hz~254.1Hz, a
total of 51 groups DCS code: 000N~7771, a total of 1024 groups.
7.Optional Signal
Allows the set up of DTMF/5TONE/2TONE encode and decode for the analog
channels.
9.Squelch mode
When the analog channel is set up for both CTCSS/DCS decoding and optional
signaling, you can set up the RX condition in this menu.
SQ: You can hear the call when the channel receives a matched carrier.
CDT: You can hear the call when the channel receives a matched CTCSS/ DCS signal
26
Advertisement
Table of Contents
