Table of Contents
Advertisement
1. Introduction, Features and Applications
Introduction
The DM432C is a versatility fully digital stepping driver based on a DSP with advanced control
algorithm. The DM432C is the next generation of digital stepping motor controls. It brings a
unique level of system smoothness, providing optimum torque and nulls mid-range instability.
Motor auto-identification and parameter auto-configuration technology offers optimum responses
with different motors and easy-to-use. The driven motors can run with much smaller noise, lower
heating, smoother movement than most of the drivers in the markets. Its unique features make the
DM432C an ideal solution for applications that require low-speed smoothness.
Features
l Anti-Resonance, provides optimum torque
and nulls mid-range instability
l Motor auto-identification and parameter
auto-configuration
technology,
optimum responses with different motors
l Multi-Stepping allows a low resolution step
input to produce a higher microstep output
for smooth system performance
l Microstep resolutions programmable, from
full-step to 102,400 steps/rev
Applications
Suitable for a wide range of stepping motors, from NEMA size 14 to 23. It can be used in various
kinds of machines, such as laser cutters, laser markers, high precision X-Y tables, labeling machines,
and so on. Its unique features make the DM432C an ideal solution for applications that require
low-speed smoothness.
Tel: +086 0755-26434369
DM432C Microstepping Driver Manual V1.0
l Supply voltage up to +40 VDC
l Output current programmable, from 0.1A to
3.2A
l Pulse input frequency up to 200 KHz
offers
l TTL compatible and optically isolated input
l Automatic idle-current reduction
l Suitable for 2-phase and 4-phase motors
l Support PUL/DIR and CW/CCW modes
l Over-voltage,
over-current,
protections
1
Web Site: www.leadshine.com
2. Specifications
Electrical Specifications (T
Parameters
Output current
Supply voltage
Logic signal current
Pulse input frequency
Isolation resistance
Mechanical Specifications
phase-error
Elimination of Heat
l
Driver's reliable working temperature should be <70 ℃ (158℉), and motor working temperature
should be <80 ℃ (176℉);
l
It is recommended to use automatic idle-current mode, namely current automatically reduce to
60% when motor stops, so as to reduce driver heating and motor heating;
l
It is recommended to mount the driver vertically to maximize heat sink area. Use forced cooling
method to cool the system if necessary.
Tel: +086 0755-26434369
DM432C Digital Stepping Driver Manual V1.0
= 25℃/77℉)
j
DM432C
Min
Typical
Max
0.1
-
3.2 (2.3 RMS)
+20
-
+40
7
10
16
0
-
200
500
(unit: mm
[inch])
Figure 1: Mechanical specifications
2
Web Site: www.leadshine.com
Unit
A
VDC
mA
kHz
MΩ
Advertisement
Table of Contents
