Table of Contents
Advertisement
Error
Code
Error Contents and Cause
(SD0)
The received command differs from the
8330
expected value.
Lapse in separated receiving data has
8331
occurred.
The link ID in receiving data is different
8332
from the expected value.
The running No. in receiving data is
8333
different from the expected value.
The CC-Link Safety master station
8334
cannot recognize the separated data.
Annunciator (F) was set ON
9000
(**** in the error message indicates the
detected annunciator number.)
Corrective Action
• Check the cable status visually or by
a line test.
• Hardware error of the CC-Link Safety
master module or the relevant CC-
Link Safety remote module (Contact
your local Mitsubishi representative.)
• Check if the link ID setting of the
relevant remote station and the link
ID that has been set in the network
parameter are identical.
• Hardware error of the CC-Link Safety
master module or the relevant CC-
Link Safety remote module (Contact
your local Mitsubishi representative.)
• Check if the setting value of the
Safety refresh monitoring time is
appropriate.
• Hardware error of the CC-Link Safety
master module or the relevant CC-
Link Safety remote module (Contact
your local Mitsubishi representative.)
• Check the cable status visually or by
a line test.
• Hardware error of the CC-Link Safety
master module or the relevant CC-
Link Safety remote module (Contact
your local Mitsubishi representative.)
Read the individual information of the
error using the GX Developer, and
check the program corresponding to the
numerical value (annunciator number).
9.1.8 Error code list (8000 to 9000)
Corresponding
CPU
QS
QS
QS
QS
QS
QS
9.1 Error Code List
9
9-35
Advertisement
Table of Contents
