DMA-# assigned to
Assign IRQ for USB
3. Press <ESC> and follow the screen instructions to save or
disregard your settings.
Load Setup Defaults
Load Setup Defaults option loads the default system values
to the system configuration fields. If the CMOS is corrupted
the defaults are loaded automatically. Choose this option
and the following message will appear:
"Load Setup Defaults (Y/N)? N"
To use the Setup defaults, change the prompt to "Y" and
press <Enter>.
3. Press <ESC> and follow the screen instructions to save or
When resources are controlled manually,
assign each system DMA channel as one
of the following types, depending on the
type of device using the interrupt:
Legacy ISA Devices compliant with the
original
PC
requiring a specific interrupt ( such as
IRQ4 for serial port 1). PCI/ISA PnP
Devices compliant with the Plug and Play
standard, whether designed for PCI or ISA
bus architecture.
Choose Enabled (default) or Disabled.
Enabled: Add one IRQ to USB controller.
Disabled: Remove IRQ from USB
controller. The system will have
extra IRQ for other devices but
the USB controller will still
not be disabled (only IRQ
was removed.)
AT
bus
specification,
37