Screwing The Cleaning Device To The Underlying Surface; Screwing The Cleaning Device And Installation Stand To The Underlying Surface - Fronius Robacta Reamer V Twin Operating Instructions Manual

Screwing the cleaning device to the underlying
surface
Screwing the
NOTE!
cleaning device
and installation Different fixings may be required to set up the installation stand depending on
stand to the un- the type of underlying surface (foundation).
derlying surface Fixings are therefore not included in the scope of supply of the installation stand.
The installer is responsible for selecting the right type of fixing.
1
2
4 x
Screwing the
NOTE!
cleaning device
Different fixings may be required to set up the device depending on the type of
to the underlying
surface underlying surface (foundation).
The fixings supplied may only be used on an underlying surface (foundation)
thickness of 5 mm (0.197 in.) or less.
Do not use the fixings supplied to set up the device on an underlying surface
(foundation) thickness greater than 5 mm (0.197 in.). In this situation the in-
staller is responsible for selecting the right type of fixing.
1
Place the optionally available installation stand on a level, firm and vibration-
free surface (foundation)
- Position the installation stand in such a way that the distance the robot
has to travel to the cleaning device on the installation stand is as short as
possible
Screw the installation stand to the underlying surface (foundation) using the
appropriate fixings
Place the cleaning device on a level, firm and vibration-free surface (founda-
tion)
- Position the cleaning device in such a way that the distance the robot has
to travel to the cleaning position is as short as possible
Position the cleaning device on the
3
installation stand
Position the spatter tray on the
4
cleaning device as shown
Securely screw the cleaning device
5
and spatter tray to the installation
stand as shown. Use the fixings
supplied with the cleaning device
33