Scope Of Supply; Available Options; How The Wire Cutter Works/Maximum Wire Diameter - Fronius Robacta Reamer V Twin Operating Instructions Manual

Scope of supply

not shown:
(5)
(6)
(7)
Available op- The following options are available for the cleaning device:
tions
-
-
-
How the wire
The wire cutter opens and closes when there is an active signal from the robot
cutter works/ control.
Maximum wire
diameter Two wire electrodes with a diameter of up to 1.6 mm (0.063 in.) can be cut at the
same time by the cleaning device wire cutter.
NOTE!
If you change over to a new welding torch, the wire cutter must be reset!
16
Standard I/O connecting plug (X1) without cable
Operating instructions
Fixings for assembling the cleaning device:
- 4 screws
- 4 washers
- 4 lock washers
- 4 nuts
Installation stand
Cleaning cutter adjustment aid
Level sensor
NOTE!
The "Robacta Reamer" parting agent
(1)
(item number 42,0411,8042) and the
cleaning cutter are not part of the
scope of supply.
(1) Robacta Reamer V Twin clean-
ing device with wire cutter
(2) Spatter tray
(3) Tightening key for cleaning mo-
(2)
tor
(3)
(4) Compressed air relief valve
(4)