Adjust The Swivel Mechanism Stop Angle - Fronius Robacta Reamer V Twin Operating Instructions Manual

Adjust the swivel -
mechanism stop -
angle
3
4
5
6
74
Banking screw (4) adjusts the left stop angle
Banking screw (5) adjusts the right stop angle
Manually tilt the cleaning motor to the side to be adjusted and move to the
highest position
Adjust the respective banking screw so that the cleaning cutter cannot col-
lide with a contact tip or a gas nozzle
Return the cleaning motor to the lowest position
Secure the banking screw using the nut (2) or (3) undone previously
Undo nut (2) or (3) depending on
1
the stop angle to be adjusted
Depending on the stop angle to be
2
(4)
adjusted, undo banking screw (4)
or (5) until the cleaning motor can
(2)
be moved to the highest position
where it is not in contact with the
welding torch parts
(3)
(5)
Manually move the cleaning motor
7
to the highest position
Manually tilt the cleaning motor to
8
0,5-1mm
0.02-0.004in
the left and right
-
the cleaning cutter must not
collide with the contact tips or
gas nozzle
If the cleaning cutter touches
9
welding torch components, adjust
the stop angle again
2-3mm
0.08-0.12in