Emergency Stop - Renishaw Kiosk workstation User Manual

Kiosk workstation user's guide
www.renishaw.com
Kiosk workstation safety
Where this symbol is displayed on the product the user must refer to the installation and user guide for information and safety
advice.
If the equipment is used in a manner not specified by the manufacturer then the safety of the equipment may be impaired.
WARNING: To prevent unexpected machine movement, the user is advised to isolate the machine from the electricity supply,
compressed air or other energy sources in accordance with the machine manufacturer's instructions before entering the danger
zone or performing any maintenance operations.
WARNING: The user's guide must be consulted in all cases where this symbol is used on the equipment, in order to find out the
nature of the potential hazard and any actions which have to be taken.

Emergency stop

NOTE: Emergency stop is not considered to be a primary means of risk reduction for the hazards presented at a machine. All
precautions advised by the machine manufacturer, the Renishaw product documentation and health and safety literature should be
considered in determining the safety strategy for the use of this equipment.
The Renishaw system may provide the following safety categories, to standard EN ISO 13849, according to the type of servo amplifier fitted:-
SPA2-2: Category 2
The choice of the stop category of the emergency stop depends on the results of the user's risk assessment of the machine.
The emergency stop system, provided within the Renishaw servo amplifiers, has provision for the integration of external actuating devices.
The user should advise Renishaw of the requirements for such devices resulting from risk assessment.
Any emergency stop devices supplied by the user must comply with the requirements of UL1054 (EN60947) or other appropriate standards.
WARNING: Risk of toppling
The unit is provided with casters to help manoeuvre it into position. Take care pushing the kiosk, especially over rough surfaces.
Push the kiosk below the mid-point or have a second person hold the unit steady as it is moved.
Once in place, the unit should be fixed to the floor using the fixing holes provided.
Issued 10 2022
5