Table of Contents
Advertisement
Using the Control Knob (K) move the square frame to the desired
cell to be changed. The green dotted lines shown above indicates the
sequence of cell selection based on Control Knob rotation.
At the desired cell, press the Control Knob (K) to activate this cell. The
cell now changes to solid color as shown below.
To increase the setting rotate the knob clockwise or counter clockwise
to decrease it (except for the AM/PM cell where the information
switches in either direction). Press the Control Knob (K) to confi rm
the change.
Once confi rmed, the same cell changes from a solid color back to a
square frame.
Move to the next desired cell and follow the same steps to make
changes or select the Cancel Button to exit out of this selection change
and go back to the main settings screen.
Note: The date and time will need to be re-set if the battery and power
supply are disconnected for more than 2 months.
If the user does not set up the time and date after connecting the
mixer to the power supply or inserting a battery, the device will display
the following default settings: 00:00 AM and 01/01/00.
5.4.2. Passcode
To change the Passcode, follow the steps detailed in 5.4 above under
"Setting mode" to activate its cell and do the following:
Once the "Passcode" is activated the page below will open requesting
users to enter the current passcode.
22
eAdvantage User Manual (15PL1033 Rev. 7, July 2022)
Advertisement
Table of Contents
