Prestart Inspection; Check The Engine Oil Level; Change The Engine Oil And Filter - SANY SY16C Operation And Maintenance Manual

SY16C Excavator OMM

Prestart Inspection

For more information, see "Daily Inspection and Maintenance" on page 5-11.
Pre-start Check
Check the engine coolant level and top off as
necessary.

Check the engine oil level.

Check the fuel level and add as necessary.
Drain water from the fuel/water separator.
Check hydraulic oil level and add as necessary.
Check the electrical wires and connectors for damage.
Check the horn operation.

Check the Engine Oil Level

See "Engine Oil Level Check" on page 4-8.

Change the Engine Oil and Filter

1. Prepare the machine for service. See "Maintenance Safety" on page 2-9.
NOTICE!
Dispose of used oil and filter in accordance with all applicable environmental regulations.
Failure to do so could damage the environment.
NOTE: For engine oil capacity, see "Fluid Capacities" on page 5-9.
2. Place a suitable container under the drain plug (1).
3. Remove the drain plug and allow the oil to drain.
4. Install the drain plug.
SANY
"Engine Coolant Level Check" on page 4-7
"Engine Oil Level Check" on page 4-8
"Fuel Level Check" on page 4-9
"Drain the Fuel/Water Separator" on page 4-10
"Hydraulic Oil Level Check" on page 4-11
"Electrical Components Check" on page 4-13
"Horn Function Check" on page 4-13
Fig. 5-3
Operation and Maintenance Manual — 0420
Maintenance
Reference
1
0003218
5-19