Properly Aligning The Charger - Boston Scientific Vercise DBS Handbook

Vercise DBS Charging Handbook
TM

Properly Aligning the Charger

1. Press the power button. The indicator light will come on again,
and the Charger will begin beeping repeatedly to signal that it
is searching for the Stimulator.
2. Position the Charger over the Stimulator.
The beeping will stop when the Charger is partially aligned
with the Stimulator. For optimal charging, make sure the
Charger is centered over the Stimulator (Figure 4).
Charging time may increase if the Charger is not fully
aligned with the Stimulator. To fully align the Charger over
the Stimulator, position the bottom curve of the Charger
approximately 1 cm lower than the bottom curve of the
Stimulator.
If you are having trouble properly aligning the Charger or experiencing longer than normal charging times, see the "Tips for
Properly Aligning the Charger" section of this manual.
Vercise DBS Charging Handbook
TM
91171709-15 Page 12 of 109
Figure 4. Position the Charger Over the Stimulator