Configuring The Vx6 With Lxeconnect; Install Lxeconnect; Figure 1-7 Activesync Explore - LXE VX6 Reference Manual

Configuring the VX6 with LXEConnect

Configuring the VX6 with LXEConnect
Requirements: ActiveSync version 3.8 (or higher) must be resident on the host (desktop/laptop)
ActiveSync is already installed on the VX6. The VX6 is preconfigured to establish a USB
ActiveSync connection to a PC when the proper cable is attached to the VX6 and the PC. If The
VX6 uses a serial port for ActiveSync, it is necessary to configure the VX6 to use the serial port.
Complete details on the proper cables and port configuration are included in the ActiveSync
section later in this chapter.
LXEConnect allows a user to view the VX6 screen remotely from a PC using an ActiveSync
connection.

Install LXEConnect

1. Install Microsoft ActiveSync version 3.8 or higher on a PC with a USB port. For details,
please see ActiveSync later in this chapter.
2. Power up the VX6.
3. Connect the VX6 to the PC using the proper connection cable.
ActiveSync dialog box appears. If using the USB connection, the ActiveSync connection is
automatically established.
connection from the VX6.
4. Select "No" for partnership when prompted. Dismiss any ActiveSync dialog boxes warning a
partnership is not set up. It is not necessary to establish a partnership to use LXEConnect.
However, if a partnership is desired for other reasons, one may be established now. More
details on partnerships are included in ActiveSync later in this chapter.
5. When the ActiveSync screen appears, select Explore.
6. An explorer window is displayed for the VX6. Browse to the \System\LXEConnect folder.
E-EQ-VX6RG-H
computer. Please see the following section ActiveSync – Initial Setup for more
details on ActiveSync.
If using a serial connection, it is necessary to initiate the

Figure 1-7 ActiveSync Explore

13
Once connected, the
VX6 Reference Guide