connected Ethernet device to see if it responds.
11.1 To enable the "Command Line mode", click Run in the Start menu, type
Command, and click OK to continue.
11.2 Type ping 192.168.1.1 command to check the connection. Here we use IP
address 192.168.1.1 as an example. Before the testing, be sure your PC
host and target device are in the same subnet.
10. Repeat step 10 to make sure that the connection of each device connected to
the JetNet 2205 series product is successfully established.
11. Power on the host, activate the Command Line mode, and ping the connected
Ethernet device by typing "ping –t 192.168.1.1" command to see if it will
13