Table of Contents
Advertisement
Use Phillips head screwdriver to remove the
screw from the cover plate. Retain the screw for
use later in this procedure.
Then, remove the cover plate by sliding it to the
left.
Attach the cable to the connector located in the
previous step.
44
Locate the connector, just inside the unit, to connect
the cable that is attached to the GPIB module.
Put the module into the unit and slide the GPIB board
to the right so that it is flushed against the
instrument's sheet metal. Use the screw that was
removed earlier to secure the GPIB plate in place.
This concludes the GPIB installation procedure.
Keysight E36150 Series User's Guide
Advertisement
Table of Contents
