Table of Contents
Advertisement
Using the Scope Function (Option E36150ADVU)
Making measurement
Scope view
Scope marker view
Using the knob in scope view
Scope properties and waveform settings
Scope marker properties
Save the scope data
The scope function is similar to a bench oscilloscope, displaying output voltage and current signals as a function of
time. It has controls that select which outputs and functions to display, front panel knobs that adjust gain and offset,
and configurable triggers and markers.
You can configure the Scope View to display voltage or current waveforms for all outputs. As explained under
Horizontal Settings (Hr), the maximum sampling rate of the scope varies, depending on the number of waveforms
that are displayed. Note that in the Scope View there is only one time-base and trigger configuration for all outputs.
Making measurement
In the following measurement example, an output turn-on sequence is displayed using the oscilloscope. The
oscilloscope measures the actual voltage as the output turns on.
Step 1 – Program the output voltage and current values
In Meter View, set the output voltage and current to 1 V and 4 A. This is described under
Controlling the
Output.
Step 2- Configure the output turn-on sequence
Configure the output turn-on sequence as described under
Configuring the Output Turn-On/Turn-Off
Sequence.
Note that you will only need to configure the Turn-on delays, not the turn-off delays.
The turn-on delays for the output channels are as follows:
130
Keysight E36150 Series User's Guide
Advertisement
Table of Contents
