Table of Contents
Advertisement
Items
12 Trigger point indicator
Menu
Datalog Run Stop
Knob
Scale or Ofs
Sc, Ofs, or Mrk
Marker On or Off
Properties
Auto Scale
Data logger marker view
Items
1
m1/m2 points
2
m1
3
m2
4
Delta
Keysight E36150 Series User's Guide
Indicates the trigger position in the data log. In this example the trigger point was offset by
0%, and the pre trigger and post trigger data was logged. The time at the trigger point is
always zero. Change the trigger offset in the Data Logger Logging Settings.
Run or stop data logging.
Scale or Ofs
Marker (Mrk) only appear when Marker is enabled.
Selecting Mrk set the function of the Vertical and Horizontal knob to adjust the m1 and m2 marker position.
See
Using knob in data logger
Enables or disables the Marker view.
Sets the data logging and waveform displays properties. See
tings
.
Auto scales the traces on the display.
Shows where the measurement markers intersect the selected waveform. Data values at the bottom of the dis-
play are referenced to the intersect locations of the markers. Calculations are based on the data points in
between the intersect locations.
Indicates the m1 marker value in volts, amps, or watts at the intersection point. Also indicates the distance in
time of the m1 marker in relation to the present trigger position. If a marker is out of view, an arrow indicates the
direction of the marker
Indicates the m2 marker value in volts, amps, or watts at the intersection point. Also indicates the distance in
time that the m2 marker is in relation to the present trigger position. If a marker is out of view, an arrow indic-
ates the direction of the marker
Indicates the delta or absolute difference between the markers in units (volts, amps, or watts) and in time
(seconds).
Description
view.
Description
.
.
Description
Data logger properties and waveform set-
121
Advertisement
Table of Contents
