Nexgrill NEEVO 720-1055 Owner's Manual page 33

WARNING: BEFORE LIGHTING
•
Inspect the gas supply hose prior to turning the gas "ON". If there is evidence of cuts, wear, or
abrasion, it must be replaced prior to use. Do not use the grill if the odor of gas is present. Only the
pressure regulator and hose assembly supplied with the unit should be used. Never substitute
regulators and hose assembly for those supplied with the grill. If a replacement is necessary,
contact the manufacturer for proper replacement. The replacement must be that specified in the
manual.
•
Always plug the power cord into a grounded outlet.
•
Open the grill lid while lighting.
CAUTION: Always keep your face and body as far away from the burner as possible when lighting.
Every Neevo grill undergoes thorough safety testing during
manufacturing. Therefore, the burners will appear discolored as a
result of operational inspections.
Automatic Self Test
Each time the grill is connected to power, the controller must initialize and perform a self diagnostic test to confirm
all valves and necessary connections are working properly before use. This test will last 18 seconds and starts
immediately once the power cord is connected. Once the test passes, the power button will illuminate red to
indicate it is in standby. If the test fails, three beeps will sound. In this case, unplug the grill and repeat.
For more assistance call our Customer Service Department at 1-800-913-8999 in USA or 1-800-648-5864 in
Canada, 8 a.m. - 5 p.m., PST, Monday-Friday. You can also reach us by email at:
CustomerService@grillservices.com.
LIGHTING YOUR GRILL - AUTOMATICALLY
Make sure your grill is properly setup and ready for use.
1. Make sure the grill is powered off, then open the cylinder valve on the LP tank.
2. Plug the digital grill power cord into a properly grounded electrical outlet. Power button red LED will flash.
3. Press POWER. The main LED display will show the current furnace temperature.
4. Open the grill lid.
5. Press MODE, then press ZONE A. To turn on the second burner, press MODE then press ZONE B. During
ignition, the grill will produce a snapping sound while the ignition icon and zone icon flash. After the ignition is
successful, the ignition icon will turn off and the zone icon will stay on. The default set temperature for one burner
is 300 ˚F (149 ˚C) and for two burners is 450 ˚F (232 ˚C).
6. Once a single burner or both burners are lit, the zone indicator(s) will illuminate on the controller and on the
control panel. Turn the dial to the desired grill targeted temperature and push the dial to confirm change. The
temperature range of a single burner is 250 ˚F - 450 ˚F (121 ˚C - 232 ˚C). The temperature range for the two burners
is 450 ˚F - 600 ˚F (232 ˚C - 316 ˚C).
Note: The digital smart grill and air oven can both be operated simultaneously when both power supply cords are
plugged in.
DO NOT ATTEMPT TO LIGHT THE GRILL IF ODOR OF GAS IS PRESENT. CALL FOR
SERVICE at 1-800-913-8999 (US) or 800-648-5864 (Canada).
TURNING OFF YOUR GRILL
1. To shut down individual burners, press and hold the corresponding ZONE button for 3 seconds.
2. To immediately shut down the grill, press the POWER button.
3. After shutting down, unplug the grill from the power source.
4. Wait until the grill has cooled down before storing it.
Unplug both the digital grill and air oven power cords before moving, storing, or servicing the appliance.
DO NOT LEAVE THE GRILL UNATTENDED WHILE COOKING.
Grill OPERATING INSTRUCTIONS
Notice!
33