Configuration And Startup - Emerson Rosemount OCX8800 Quick Start Manual

Oxygen and combustibles transmitter

Hide thumbs Also See for Rosemount OCX8800:

February 2020

Configuration and startup

WARNING

Failure to install covers and ground leads could result in serious injury or

death.

Install all protective equipment covers and safety ground leads after

installation.

3.1

Verify installation

Ensure the transmitter is installed correctly. Verify mechanical installation

and all electrical and pneumatic connections.

CAUTION

Damage can result from having a cold transmitter exposed to the process

gases.

Make sure that the transmitter is turned on and operating prior to firing

up the combustion process.

During outages, and whenever possible, leave all transmitters running to

prevent condensation and premature aging from thermal cycling.

3.1.1

Verify configuration - Fieldbus electronics

There is one switch on the microprocessor board which must be set for the

Rosemount OCX8800 with Fieldbus electronics

the sample line heater control circuit. This switch is accessible through holes

in the electronics box.

CAUTION

If defaults are changed under power, damage to the electronics may occur.

Remove power from the Rosemount OCX8800 before changing defaults.

Quick Start Guide

(Figure

3-1). SW3 configures

Table of Contents