Sullair LS20TS Operator's Manual And Parts List page 23

3.1 SPECIFICATIONS- LS20TS
Model Series
LS20T 800 CFM
LS20T 960 CFM
LS20T 1100 CFM
LS20T 1450 CFM
(I) Add an additional mm to Height for enclosed models. Add an additional mm to height for air inlet cap.
(II) Add kg for enclosed models.
For noise level information, please contact the Sullair Factory Service Department.
COMPRESSOR:
Type:
Maximum Full Load Operating Pressure:
Bearing Type:
Cooling:
Lubricant:
Sump Capacity:
Control:
MOTOR:
Type:
Size:
Speed:
3.2 LUBRICATION GUIDE-STANDARD COMPRES-
SORS
Refer to Figure 3-1
standard compressors are filled with Sullube fluid
as factory fill.
To be sure that you receive the correct fluid for
your compressor, when ordering fluid, always
confirm your compressor's fluid fill with the parts
technician by using your compressor's serial
number.
Mixing of other fluids within the compressor will
void all warranties.
Sullube fluid should be changed every 1200 hours
or once a year, whichever comes first. The fluid
should be changed more frequently under severe
operating conditions, such as high ambient temper-
atures coupled with high humidity, or when high
Length
in mm
157 3988
157 3988
157 3988
157 3988
for fluid fill port location. Sullair
DIMENSIONS WITHOUT ENCLOSURE (I)
Width
in mm
72 1821
72 1821
72 1821
72 1821
2-Stage Oil Flooded Rotary
350 psig (24.1 bar)
Anti-Friction
Pressurized Compressor Fluid
Sullube
50 U.S. Gallons (189.3 Liters)
Supervisor Controller
O.D.P., 460V, A.C., Three Phase, 60 Cycles
300, 350, 400, 450, 500, 600HP
1800 RPM
Figure 3-1 Fluid Fill Port Location
KEY
A FLUID FILL PORT
B SIGHT GLASS
SUMP/SEPARATOR
C
TANK
When performing a fluid
change or topping off the
fill, the proper level should
be at half of the sight glass,
with the machine off.
SPECIFICATIONS
Height
in mm lb
92 2339 (II)
92 2339 (II)
92 2339 (II)
92 2339 (II)
Section 3
Weight
kg
(II)
(II)
(II)
(II)
17