ycom eSC S1-X User Manual page 42

HRM_BeatRate
SensorContactStatus
Throttle_SCU
BOOST COUNT
BOOST KILL
Undevoltage Alarm R
V_Sat
Acc_lat
Acc_lon
Rollangle
V_Scooter
SCU Serial Number
BoP Coeff
Map Limit BoP
BOOST Limit BoP
DASH
The Dah has 3 different pages:
Page 1 going up when the scooter is turned ON (Main Switch in P1) and shows all the basic info:
In this page the upper LEDs light up if the rider turns the throttle.
Page 2 is shown when the scooter goes over 10 Km/h and shows the selected maps (front and rear), the voltage of the
battery and the remaining boost seconds. In this page, the LEDs light up if there is a temperature alarm (showing a text
message).
number heart beat rate
number Number that identifies HRM sensor is connected (6=no
connection - 22=connection)
% Throttle demand
s Seconds of remaining Boost
number Number that identifies if boost or kill is pressed (1=Boost
2=Kill)
number Alarm that cut the current (of the rear motor) to 30% if the
battery voltage goes down 48V for more than 10 sec
km/h GPS Scooter speed
m/ss Lateral acceleration of the scooter (calculated)
m/ss Longitudinal acceleration of the scooter (calculated)
Deg Lean angle of the scooter (calculated)
km/h Scooter speed (calculated)
number Serial number of the SCU installed in the scooter
number Balance of Performance coefficient applied in the SCU
% Percentage of the map available after the BoP equalization
% Percentage of the Boost available after the BoP equalization
Table 6 - List of recorded channels
Image 23 - Page 1 that shows all basic info's of the eSkootr
| eSC S1-X – User manual
42