HP ProLiant ML30 Gen10 Plus User Manual page 146

11. If no M.2 SSD will be installed on the iLO-M.2-serial module, install the SSD mounting screw and hex nut removed on step 9 on the
M.2 22110 standoff on the module .
Installing an M.2 SSD Installing an M.2 SSD
12. To locate the M.2 standoff on the correct position:
a. Verify that the M.2 standoff position in the module matches the length of the SSD .
b. Install the hex nut removed on step 9 on the M.2 standoff location.
13. Install the SSD:
a. Insert the SSD into the M.2 slot at a 45° angle (callout 1).
b. Carefully press the SSD down to the horizontal position (callout 2).
c. Install the SSD mounting screw (callout 3).
Installing the serial port cable Installing the serial port cable
14. Remove the serial port blank.
Installing the iLO-M.2-serial module 146