Installing The Pci Fan And Air Baffle - HP ProLiant ML30 Gen10 Plus User Manual

Installing the PCI fan and air baffle

Installing the PCI fan and air baffle
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If needed, disconnect any system cables that might be blocking access to the bottom side of the drive cage.
8. Install the PCI fan:
a. Align the spool on the chassis wall with the notches on the fan (callout 1).
b. Install the fan screws (callout 2).
Installing the PCI fan and air baffle 115