KYMCO Agility Carry 50i Manual page 122

9. DRIVE AND DRIVEN PULLEYS
Check the driven face for wear or damage.
Measure the driven face O.D.
Service Limit: 33.94mm replace if below
Check the movable driven face for wear or
damage.
Measure the movable driven face I.D.
Service Limit: 34.06mm replace if over
DRIVEN PULLEY FACE BEARING
REPLACEMENT
Drive the inner needle bearing out of the
driven pulley face.
Discard the removed bearing and replace with
a new one.
Remove the snap ring and drive the outer
bearing out of the driven face.
Apply grease to the outer bearing.
Drive a new outer bearing into the driven face
with the sealed end facing up.
Seat the snap ring in its groove.
＊
Pack all bearing cavities with 5.0～5.6g
grease.
Specified grease: Heat resistance 230C
9-9
Agility Carry / Delivery 50i
Inner Bearing
Snap Ring
Outer Bearing
Bearing Remover