Hardware Design - Ebyte E104-BT02 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.

9 Hardware design

It is recommended to use a DC stabilized power supply. The power supply ripple factor is as small as possible and the module

needs to be reliably grounded;
Please pay attention to the correct connection of the positive and negative poles of the power supply, reverse connection may

cause permanent damage to the module;
Please check the power supply to ensure that between the recommended supply voltage, if exceeding the maximum, the module

will be permanently damaged;
Please check the stability of the power supply. Voltage can not fluctuate greatly and frequently;

When designing the power supply circuit for the module, it is often recommended to reserve more than 30% of the margin, so the

whole machine is beneficial for long-term stable operation;
The module should be as far away as possible from the power supply, transformers, high-frequency wiring and other parts with

large electromagnetic interference;
Bottom Layer High-frequency digital routing, high-frequency analog routing, and power routing must be avoided under the

module. If it is necessary to pass through the module, assume that the module is soldered to the Top Layer, and the copper is
spread on the Top Layer of the module contact part(well grounded), it must be close to the digital part of the module and routed
in the Bottom Layer;
Assuming the module is soldered or placed over the Top Layer, it is wrong to randomly route over the Bottom Layer or other

layers, which will affect the module's spurs and receiving sensitivity to varying degrees;
It is assumed that there are devices with large electromagnetic interference around the module that will greatly affect the

performance. It is recommended to keep them away from the module according to the strength of the interference. If necessary,
appropriate isolation and shielding can be done;
Assume that there are traces with large electromagnetic interference (high-frequency digital, high-frequency analog, power traces)

Copyright ©2012–2019, Chengdu Ebyte Electronic Technology Co.,Ltd.
E104-BT02 User Manual
28