Installing The Actuator - Toro 147-1660 Manual

4. Pull the boot cover off the positive battery
terminal.
5. Remove the nut from the positive battery
terminal and install the kit wire harness positive
terminal ring onto the bolt
6. Secure the positive terminal ring using the
previously removed nut
7. Install the boot cover over the positive battery
terminal.
8. Remove the nut from the negative battery
terminal and install the kit wire harness negative
terminal ring onto the bolt
9. Secure the negative terminal ring using the
previously removed nut
Figure 17
1. Positive terminal bolt
2. Negative terminal bolt
3. Negative terminal nut
(Figure 17).
(Figure 17).
(Figure 17).
(Figure 17).
g346611
4. Kit wire harness negative
terminal ring
5. Positive terminal nut
6. Kit wire harness positive
SUPERCEDED
terminal ring
10

Installing the Actuator

Parts needed for this procedure:
1 Actuator
2 Pin clip
1 Aluminum spacer
1 Clevis pin
Procedure
1. Secure the actuator to the rear deck-lift arm
using the pin clip
1. Actuator
2. Pin clip
2. Rotate the actuator upward and align the
actuator with the holes in the actuator mount.
If the holes do not align, turn the machine on,
and carefully press the deck-lift switch on the
motion-control lever up or down until the holes
align.
9
(Figure 18).
Figure 18
3. Rear deck-lift arm
g346588