12
Checking the Mower Deck
Height of Cut and Rake
No Parts Required
Procedure
Refer to the Adjusting the Side-to-Side Leveling and
the Blade Slope procedure in the Operator's Manual.
Operation
Adjusting the Height of Cut
For Machines with an Electric
Deck Lift
1.
Push up on the deck-lift switch
Figure 21
1. Push up to raise the deck.
2.
Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, and
insert the pin
(Figure
3.
Push down on the deck-lift switch until the
height-of-cut linkage slightly contacts the
height-of-cut pin
(Figure
21).
SUPERCEDED
2. Push down to lower the
deck.
22).
(Figure
22).
Note:
Too much contact between the
height-of-cut linkage and height-of-cut pin can
negatively affect the mower deck height of cut
and leveling.
1. Height-of-cut pin
2. Height-of-cut linkage
g332765
11
Figure 22
3. Height-of-cut bracket
g361935