Toro 147-1660 Manual page 8

6
Installing the Actuator
Mount and Rear-Lift
Hardware
Parts needed for this procedure:
1 Pivot pin
1 Locknut (1/2 inch)
1 Actuator mount
2 Carriage bolt (5/16 x 1 inch)
2 Locknut (5/16 inch)
Procedure
1. Secure the pivot pin to the rear deck-lift arm
using 1 locknut (1/2 inch) as shown in
1. Locknut (1/2 inch)
2. Pivot pin
Figure
SUPERCEDED
Figure 9
3. Rear deck-lift arm
2. Secure the actuator mount to the left frame tube
using 2 carriage bolts (5/16 x 1 inch) and 2
locknuts (5/16 inch) as shown in
1. Left frame tube
2. Actuator mount
9.
g346401
6
Figure
Figure 10
3. Locknut (5/16 inch)
4. Carriage bolt (5/16 x 1
inch)
10.
g399232