Table of Contents
Advertisement
14.7. Possible states of the product
OFF: The product is "deactivated" and does not produce heat; this because it has been switched off manually by
pressing ON/OFF on the display or due to the triggering of an external contact (chrono prog., telephone dialler). The
OFF screen is switched to the ON screen by pressing the ON/OFF key for 3 seconds.
ON: Situation in which the product is "active" and can satisfy the heat demands.
ALARM: If the product is blocked due to an Alarm, the type of alarm will be shown on the display. See the paragraph
"Advice for possible inconveniences".
ON/OFF WITH STAND-BY ACTIVE: If the product was working, it switches to minimum power and waits for the set
time before switching off. If the product was being switched on, it completes the start-up phase, switches to minimum
power and waits for the set time before switching off. If the product was OFF and it is turned ON, it immediately goes
into stand-by, without switching on.
After installation and commissioning, we recommend reviewing all daily operations and useful
documents with the technician. In particular: use of the display, pellet loading, maintenance,
what to do in case of problems.
14.8. Menu
The items of the user menu are the following. The others are only for the technician or to be read under his/her
guidance.
Next to the temperature, the progressive number of the Menu item (not sequential) is displayed, called "Set
digit".
Below is the Menu item.
Example "(02 = digit; STAND BY)
STAND-BY
PELLET LOAD
CHRONO PROG.
CHRONO TEMP.(T1-T2)
DATE-HOUR
LANGUAGE
DISPLAY
AIRKARE
Order and wording may vary slightly depending on the version
50
Advertisement
Table of Contents
