USING THE SCANNER
Scanning Barcodes
After connecting the 800 Series to your device, open an application.
Place the cursor where you want to enter data.
Hold the 800 Series about 2-3 in (5-7 cm) from the barcode and press
and hold the trigger button. Make sure the red aiming beam covers the
entire width of the barcode. Keep your hand steady.
By default, the 800 Series will beep, vibrate, and the side LED will flash
green to confirm that the barcode was decoded and sent to the host
device.
SocketScan S800
SocketScan S850
~4" to 8"
~6" to 12"
scanning distance
scanning distance
13