BLOTZ B20-ST-102 Quick Start Manual

20mm Sheds (#1, #2, #3, #4 and shed pack)
B20-ST-102 / 103 / 104 / 105 / 106
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.

Shed #1 (B20-ST-102)

Remove the two sides, base, front and rear of the shed
from the sprue.
Glue the front into position.
Glue the supports to the back of one roof section.
Place or glue the roof onto the body of the shed.
Glue the sides and rear to the base.
Take the pieces of the roof.
Then glue the other roof section into place.