BLOTZ B20-ME-009 Instructions

Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the four walls shown above from the
Take the opposite side wall (top) and the other
two walls and shelter roof from the sprue.
Glue this sub-assembly to the base as shown
Attach the two inner walls to the base.
20mm Middle Eastern Building #9
B20-ME-009
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
sprue.
above.
Glue them together as shown and attach them to the
base.
Attach the two walls and shelter roof together as
shown, then glue these to the side wall.
Take the final three walls.
Then add the front wall.