Download
Share
Print this page
BLOTZ B20-MD-019 Instructions
  1. Manuals
  2. Brands
  3. BLOTZ Manuals
  4. Toy
  5. B20-MD-019
  6. Instructions

BLOTZ B20-MD-019 Instructions

20mm stables
Hide thumbs
1
2
3

Advertisement

Quick Links

Download this manual
20mm Stables
B20-MD-019
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
You may find it easier to paint portions of this model BEFORE construction – please see the end of the document for info
about this.
Take the wall sections and base from the sprue.
Take the inner walls.
Then add their partner pieces.
Glue the walls to the base with all the etched detail
facing inwards.
Add the inner wall with the lugs with the etched
detail facing to the right (see pic).
Take the outer frames.

Advertisement

loading
Need help?

Need help?

Do you have a question about the B20-MD-019 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for BLOTZ B20-MD-019

Summary of Contents for BLOTZ B20-MD-019

  • Page 1 20mm Stables B20-MD-019 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
  • Page 2 Take the frames shown above. Starting with the The door and the upper / lower supports. doorway, glue the frames into position. They will align on the left and extend out by around 3mm on the right. Glue the lower support into the doorway as Place the top support on top of the door and shown above.
  • Page 3 Attach the roof plate. Add the frame pieces to each end of the roof. Glue the desired stable doors into place. Add the insert pieces. Painting It is much easier to paint the insert sections of this building prior to assembly. They were left on the sprue and sprayed white using a car undercoat spray.