Front Runner SSDR005 Installation Instructions

Universal drawer medium suv

ENG

Universal Drawer

Medium SUV

SSDR005

READ ME !

Thank you for purchasing Front Runner Universal Drawers System.

Before you start, take a moment to familiarize yourself with the Fitting Instructions and the components received.

Refer to Page 2 for a list of all the components, quantities and tools required.

IMPORTANT WARNING!

IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD

RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT

RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND

DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO

INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY

FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.

NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.

Please call us if you have any questions about the installation of this product.

SSDR005_REV_A01

Table of Contents

Need help?

Do you have a question about the SSDR005 and is the answer not in the manual?

Page 1 FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL. NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
Page 2 6.5MM Turnbuckle M6 x 20 Hex Bolt M6 x 19 x 1SS Flat Washer M8 D-Ring M6 Nyloc Nut M8 x 16 x 1.6 Flat Washer M8 x 16 Hex Bolt FIGURE 1.1 SSDR005_REV_A01 © 2020 FRONT RUNNER VEHICLE OUTFITTERS...
Page 3 Mark the position of the D-Rings and drill 6.5MM 6.5mm holes. Secure the D-Rings using M6 x 20 Hex Bolts, M6 x 19 x 1SS Flat Washers and M6 Nyloc Nuts (Items 8, 9 & 11) 10MM SSDR005_REV_A01 © 2020 FRONT RUNNER VEHICLE OUTFITTERS...
Page 4 Do this by tightening the wing nuts up to the turnbuckles. Assemble the Eye-Nuts with a M6 Nylon Washer and a Stud Plate (Items 2, 3 & 4) and slide them into the extrusion. SSDR005_REV_A01 © 2020 FRONT RUNNER VEHICLE OUTFITTERS...
Page 5 Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions. Please call us if you have any questions about the installation of this product. INSTALL OTHER VEHICLE AND RACK ACCESSORIES Now's the time to visit your favorite Front Runner Dealer in person or Online.

Ssmp001Sstf004Sstf005Sstf003Sstp003Ssmm001