Advertisement
2
FIT AND SECURE
2.4
2.5
4
SSDR005_REV_A01
5
6
2
3
Connect the 60mm Laser Cut Carabiner
(Item 5) onto the D-rings on the drawers
upright.
Connect the Turnbuckles (Item 6) on the
other side of the 60mm Laser Cut Carabiner
and hook it into the existing tie-downs that
are fitted to the vehicle.
Secure the drawer by tensioning the
Turnbuckles until there is no more
movement on the drawer. Make sure the
drawer stays in position when doing this.
Lock the Turnbuckles with the wing nuts.
Do this by tightening the wing nuts up to
the turnbuckles.
Assemble the Eye-Nuts with a M6 Nylon
Washer and a Stud Plate
(Items 2, 3 & 4) and slide them into the
extrusion.
4
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
Advertisement
