BARRON EXITRONIX VLEDC Series Installation Instructions

Table of Contents

Download this manual

VLEDC Series

Installation Instructions

READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

When using electrical equipment, basic safety precautions should always be followed including the following:

• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.

• Installation and servicing of this equipment should be performed by qualified service personnel only.

• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations, if

applicable.

• Do not mount near gas or electrical heaters.

• Do not use outdoors.

• Do not let power cords touch hot surfaces.

• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering

by unauthorized personnel.

• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

• Any modification or use of non-original components will void the warranty and product liability.

• Do not use this equipment for other than intended use.

• Allow battery to charge for 24 hours or 48 hours before first use for models with one or two batteries,

respectively.

10070203 REV 2 - 05/22

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS!

Technical Support ■ (623) 580-8943 ■ technicalsupport@barronltg.com

800-533-3948 www.barronltg.com

Table of Contents

Do you have a question about the EXITRONIX VLEDC Series and is the answer not in the manual?

Page 1 VLEDC Series Installation Instructions IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS. When using electrical equipment, basic safety precautions should always be followed including the following: • DISCONNECT AC POWER SUPPLY BEFORE SERVICING. • Installation and servicing of this equipment should be performed by qualified service personnel only. •...
Page 2 VLEDC Series Installation Instructions Wall Mount Fig. 1 J-Box Note: Max. mounting height is 14ft Lamp Head 1. Remove the front cover from the enclosure and install the (2) Front Cover lamp heads; see Lamp Installation section. (Fig. 1) Wire Nuts 2.
Page 3 VLEDC Series Installation Instructions Lamp Installation Fig. 5 Attach lamp head 1. Remove the front cover if not completed already. male and female connector 2. Snap the lamp heads into place. (Fig. 5) Note: The lamp heads can be assembled forward or backward.
Page 4 VLEDC Series Installation Instructions Self-Test/Self-Diagnostics (G2) Operation The purpose of this option is to provide Self-testing and Self-diagnostic capabilities to the emergency unit. At predetermined intervals, the emergency unit will automatically switch into battery mode. Refer to the Self-Test Feature section below for timing details.