Setting The Scanner; Operating Twain For Mac - Kyocera KM-6030 Operation Manual

Setting the scanner

Set the scanner to be operated from a TWAIN-compatible application. Double-click [Kyocera
Scanners] in [System Preference] to open the scanner dialog.
Scanner dialog
This section explains the scanner dialog.
1
2
3
4
5

Operating TWAIN for Mac

The methods of using a TWAIN-compatible application to capture an image from the scanner are
roughly classified into two types. Perform scanning according to the situation of operation.
For starting operation from the scanner
1 Set the TWAIN mode on the scanner and set the original. For details, refer to the operation guide for
the scanner.
2
Start TWAIN for Mac from a TWAIN-compatible application.
3 Refer to Main dialog on page 8 to perform the setting for scanning.
4 Click the [Start] button. Scanning starts and the image data is sent to the Macintosh computer.
1
2
3
Devices: The names, models, and IP addresses of scanners that have been set are displayed
as a list.
Add: Click to add a scanner. The name, model, and IP address of the scanner can be set. Also,
the department management can be set if necessary. For details of the department
management, refer to the Oepration Guide for the machine.
Edit: Click to change the setting for a scanner.
Delete: Click to delete a scanner.
Make default: Click to select the scanner to be used when multiple scanners are set. The
scanner selected here can be operated from a TWAIN-compatible application.
TWAIN for Mac
4
5
7