Thermo Scientific TDE Series Manual page 34

Alarm Summary
Alarm Message
Wrong Model Alarm
Firmware Build
Incompatible
System Battery
Low Voltage Alarm
BUS Battery
Low Voltage Alarm
Stuck Button Alarm
System Battery
Failure Alarm
BUS Probe
Failure Alarm
BUS Battery
Failure Alarm
Wrong Power Alarm
Thermo Fisher Scientific ULT Freezers
Warning Remote
Icon Alarm Event
Wrench Yes
Yes
Wrench
Wrench Yes
Wrench Yes
Wrench Yes
Wrench Yes
Wrench Yes
Wrench Yes
Wrench Yes
Description
Invalid Control Model Alarm. Contact service to ensure the
correct model is selected for the system to avoid cargo
loss.
Display will intermittently show "E00".
Firmware build indicates incompatibility that can result in
modules to be non-coherent.
Display will intermittently show "E01".
System Battery voltage is too low. If error persists, the
battery may need to be replaced.
Display will intermittently show "E07".
BUS Battery voltage is too low. If error persists, the battery
may need to be replaced.
Display will intermittently show "E06".
A button has been pressed for more than 5 minutes.
Display will intermittently show "E10".
System Battery disconnected or failed.
Display will intermittently show "E12".
BUS cannot detect temperature. BUS will continuously
inject. Contact Customer service.
Display will intermittently show "E13"
BUS battery disconnected or failed.
Display will intermittently show "E14".
The unit has detected the Wrong Power connected. Verify
the proper voltage.
Display will intermittently show "EA1".
Appendix A: Alarm Summary | 29