Thermo Scientific TDE Series Manual page 10

Guidance and Manufacturer's Declaration—Electromagnetic Immunity
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
NOTE 1: UT is the AC mains voltage prior to application of the test level.
EMC Registration is done on this equipment for professional
use only. It may cause interference when the product would
be used in home.
This equipment has been tested and found to comply with the
limits for a Class A digital device. Class A covers devices for
usage in all establishments other than domestic and that are
not directly connected to a low voltage power supply
network, which supplies domestic environment.
FCC (where applicable)
This device complies with Part 15 Subpart B of the FCC
Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation. Any
changes or modifications not expressly approved by the
Thermo Fisher Scientific ULT Freezers
3 Vrms
150 kHz to 80 MHz
6Vrms for ISM bands
between 150 kHz and
80 MHz
3 V/m
80 MHz to 2.7 GHz
27 V/m
385 MHz
28 V/m
450 MHz
9 V/m
710/745/780 MHz
28 V/m
810/870/930 MHz
28 V/m
1720/1845/1970 MHz
28 V/m
2450 MHz
9 V/m
5240/5500/ 5785 MHz
3 Vrms
150 kHz to 80 MHz
6Vrms for ISM bands
between 150 kHz and
80 MHz
10 V/m
80 MHz to 2.7 GHz
27 V/m
385 MHz
28 V/m
450 MHz
9 V/m
710/745/780 MHz
28 V/m
810/870/930 MHz
28 V/m
1720/1845/1970 MHz
28 V/m
2450 MHz
9 V/m
5240/5500/ 5785 MHz
manufacturer could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
Mains power quality should be that of a
typical commercial or industrial environ-
ment.
Portable RF communications equipment
(including peripherals such as antenna
cables and external antennas) should be
used no closer than 30 cm (12 inches) to
any part of the ULT freezer, including
cables specified by the manufacturer.
Otherwise, degradation of the
performance of this equipment could
result.
Safety Considerations | 5