Intel D5005 Quick Start Manual page 26

Note: Optional settings include:
Examine the remaining option variables and adjust as appropriate for your
system.
2. Copy
(typically
RHEL:
sudo cp /usr/bin/pacd.conf /etc/sysconfig/
3. Edit the
the
pacd.conf
specify the path as absolute.
sudo vim /usr/bin/pacd.service
Edit entry:
RHEL:
EnvironmentFile=-/etc/sysconfig/pacd.conf
4. Copy
pacd
RHEL:
sudo cp /usr/bin/pacd.service /etc/systemd/system/
5. Start
Note: Please use
systemctl daemon-reload
systemctl start pacd.service
6. Optional: To enable
systemctl enable pacd.service
To check whether
the log file (specified in
Intel Acceleration Stack Quick Start Guide: Intel FPGA Programmable
Acceleration Card D5005
26
•
PCIe address (For example: -S, -B, -D, -F),
FPGA PACs matching the PCIe address components specified. For
example, if you specify -B 5 only, all Intel FPGA PACs on PCIe bus 5
becomes monitored.
• Sensor Threshold—The thresholds are global, so specifying -T
11:95.0:93.0 monitors sensor 11 on all selected Intel FPGA PACs. When
the value exceeds 95.0, it causes the default bitstream specified with -n
in pacd.conf to be programmed (PR). The sensor is considered triggered
(and no PR is performed) until its value drops below 93.0
•
Specify
-c <time period>
vary the cool down period or change
.
period>
• The Sensor Number can be found by running this command:
sudo fpgainfo bmc
to the default systemd service configuration directory
pacd.conf
).
/etc/sysconfig
file to update "
pacd.service
file was copied. Prepend the path name with a single dash '
to /etc
pacd.service
visible to systemd.
as a systemd service.
pacd
if command cannot be run in regular user mode.
sudo
to re-start on boot, execute
pacd
has started and to check state or actions, please examine
pacd
pacd.conf
A. Handling Graceful Thermal Shutdown
for
ThresholdOptions
CooldownInterval=<time
EnvironmentFile
/systemd/system/pacd.service
on the "
LogFile
UG-20202 | 2019.08.05
monitors all Intel
pacd
in
pacd.conf
" entry to reflect where
-
. This will make
" line).
Send Feedback
to
', and