Table of Contents
Advertisement
Figure 2.
Intel FPGA PAC D5005
QSFP Ports
I/O Panel with LEDs
2.2. Precautions for Hardware Installation
You must open the server chassis to install the Intel FPGA PAC. Follow all safety
precautions and the electrostatic discharge (ESD) guidelines provided to avoid
damaging the server or the Intel FPGA PAC.
Warning:
To avoid electric shock, power down your server and unplug it from the power outlet
before opening the server chassis.
ESD Guidelines
Electronics components on the Intel FPGA PAC and server are sensitive to ESD. To
avoid damaging the Intel FPGA PAC and server, follow these ESD prevention
guidelines:
•
Wear a grounded ESD strap during the Intel FPGA PAC installation.
•
Leave the Intel FPGA PAC in its ESD-safe packaging until you are ready to install
the card.
•
During installation, handle the Intel FPGA PAC only by the edge of the board.
•
Never touch any exposed circuitry, edge connectors, or printed circuits on the Intel
FPGA PAC or server.
•
Do not put the Intel FPGA PAC on any metal surface during installation.
•
If you must put the Intel FPGA PAC down, put the card in the ESD-safe packaging.
2.3. Hardware Installation
Follow these instructions to install the Intel FPGA PAC in your server.
Intel Acceleration Stack Quick Start Guide: Intel FPGA Programmable
Acceleration Card D5005
6
I/O Panel Mounting Bracket
PCIe Edge Connector
2. System Requirements and Release Installation
UG-20202 | 2019.08.05
Card Retention Hook
2x4-pin PCIe
Power Connector
Micro-USB
Send Feedback
Advertisement
Table of Contents
